Overload; Operating Anomalies - MGE UPS Systems Pulsar ES 5+ Manual De Instrucciones

overload

utility power present
1a flashing
1e on
1 beep every second
Pulsar switches off automatically after
operating in overload for approximately
5 min.
no utility power present
1a flashing
1e flashing
1 beep every second
Pulsar switches off automatically after a
length of time which depends on the level
of overload.
NB:
Overload occurs if the power consumption of
the connected applications is greater than
the rated power of Pulsar. To acknowledge
the fault, release button 3 , temporarily
disconnect Pulsar from the wall outlet
(flex 5 ), disconnect non-critical
applications and re-start Pulsar.
MGE UPS SYSTEMS

operating anomalies

device fault
1b flashing
1e on
1 beep every second
v v v v v switch off Pulsar (release button 3 ),
disconnect from the wall socket (flex 5 ),
and check that Pulsar has not short-circuited
(disconnect all applications),
v v v v v check the input fuse 6b and replace it with
a fuse of the same rating,
v v v v v re-start Pulsar.
utility power out of tolerance
1a to 1e off
...
continuous beep
after the start-up sequence, if the audio
warning device sounds continuously, check
the voltage and frequency of your
power
(see the § entitled "characteristics")
and/or recharge your battery for 8 hours.
Pulsar ES 5+: E-51032513XT/AC
battery fault
A battery test is carried out while Pulsar,
is in start-up phase, then automatically
every 7 days. If a battery fault is
detected, the following occurs:
1c flashing
1e on
1 beep every second
recharge your battery for 8 hours.
utility
NB:
If the previous symptoms persist, contact our
after sales service.
25