Duramaxx 10028871 Manual De Instrucciones página 24

Setting for Motion Sensor Operation (PIR Sensor)
The settings explained below is referred to keys on the lower portion of the inner panel. See
the Fig.3
Select ON DUTY for Day, Night or 24 hours
The WORK button is pressed once to enter the 24 HOUR > NIGHT > DAY options, the 24 (Clock)
On Duty icons will remain blinking. Press again to move the blinking icon to the SUN icon, one
more pressing will move it to the Moon. Press the OK/DEL key on your right to accept for the
desired icon and then it become stable. The Clock icon is represented for motion detection will
be valid day and night. The SUN is represented for day working. The MOON is represented for
Night working only. If ON Duty is effective, a Radar icon will run with radiation to show the
device can sense any motion in this period.
Select for Quick Shot
Quick Shot allows for more images to be taken if additional motions may be detected after the
1st image and the camera does not shut down to be ready for more instant shots. If the Burst
mode is set for OFF, you can choose 1~3 images which will allow to shot between every 20 se-
conds for an event in order to take a group animals passing-by. "1" is the default that only one
picture to be taken and then goes to PAUSE time. "2" or "3" will re-arm the sensor for taking
the second and third picture if more animals are following. (Example of use: On a trail when
you want a picture of what is following the first young deer. Like a smart buck, it always walk
at the last). A time-out of each shot is around 20 seconds. The system will goes to Pause mode
after a total number of events are done or time-out.
Note: This function is not the same as the burst mode. They will be used with difference purposes.
Pause Time
This is a time of silent between the motion sensor does able to detect event for a capture. The
sensor will not work within the gap. You can select 00, 01, 03, 05, 10, 20, 30, 45, 60 minutes
for a PAUSE option. Press the PAUSE button once to enter for setting, The default 01 will be
blinking. Press again to change it until the desired choice appears. Press OK/DEL on right to
accept it.
Change Movie Length
This option will let you determine how long for each video to take. There are 3, 5, 10, 20, 30,
45, 60, 90 seconds of video length to be selected. The PAUSE key is shared for two functions.
Press and hold the PAUSE key for 3 seconds, a blinking video camera icon will appear to let you
know you already do enter for video length setting. Then press PAUSE repeatedly until your
desired length appears. Confirm updated change by the OK/DEL key.
NOTE: You must also select VIDEO option in the camera setting when you wish to take video
clips. Otherwise, the device still does take pictures.
24