Duramaxx 10028871 Manual De Instrucciones página 33

Installing Driver for Upgrade FW in your camera
In some cases, you will be recommended to upgrade the Firmware for your camera in future,
a driver is required that you will be advised to install the driver which will be available down-
loading from the dealer's web-page or FTP-site fi rstly. After downloaded the driver into your PC
properly, connect an USB cable between PC and camera, and switch ON the main PW. Then,
press the PIC/Video and OK key at a time fi rstly, touch the CAM_PW to turn ON the camera.
Now you can see the camera small status light will be steady ON. you are ready to upgrade
the new FW now.
Downloading photos/ Movies to your computer
Press CAM-PW to turn the camera ON manually at the LIVE mode.
- Connect your computer and the camera with USB cable.
- A pop up to show the mobile hard disk which is assigned for the trail monitor device.
- For example: "H" or "I":\DCIM\100MEDIA
- Click into the proper directory to see all fi les inside.
Mounting Device
Before starting to put this camera in the fi eld for scouting game, the camera must be mounted
in a certain place properly or on a tree whose diameter will not be less than 6 inch (15cm) and
located not higher than 1M with your desired mounting method that following the installation
method as shown as below. The design is reserved to fi t for two ways of mounting.
A Belt Mount: This belt is attached in the packing.
B Python Adjustable Locking Cable (Not including in this packing).
33