Duramaxx 10028871 Manual De Instrucciones página 35

No animal showing in some pictures.
•
Check if the unit is pointed the direction where the sun is rising or sunset that the sensor
might be triggered.
The PIR sensor may detect an animals through vegetation out of view from the camera.
If the animal was moving quickly, camera may not capture it in time while an animal still
staying in the zone.
Make sure that the unit is mounted on a steady tree or other place that does not wobble.
• The Camera In-Use light is remaining ON, but the camera does not respond.
The camera may be time-out and shut down automatically. Repeat to press the CAM-PW
to resume the camera ON.
Battery may be too low that could not support the camera staying ON. Replace with 4pcs
D type brand new batteries.
The CAM-PW switch does not respond.
•
Attempt to turn the camera too quickly after the main power ON. Wait for about 10 se-
conds until the back light of scouting LCD goes to OFF. Then try again.
The Light in the front of the housing does remain ON:
•
The unit just is set for Walk-Test mode. The light remains On steady within 60s warming
up period.
The CAM-PW is not OFF. Remember to turn camera OFF after finishing usage.
• Camera seems NOT write any picture into my empty SD card and displayed with
Memory Full.
You must format the SD card which was ever used in the other device before applying it
in this camera.
Check the current SD card and try to use a brand New SD card instead of your current SD.
Trouble Shooting
35