Tools Needed - Vollrath LidSaver LS01 Manual Del Operador

IN-COUNTER INSTALLATION

Tools Needed

• #2 Phillips Screwdriver
• Drill
• 0.125" – 0.136" Drill Bit (For #8 Pilot Hole)
• Sabre Saw or Hand Router
• Cabinet Cut-Out Template (provided)
• (4) #8 x 1.00" Flat Head Wood Screws (included)
1. Use the supplied cabinet cut-out template to cut the LidSaver™ tube
hole and drill four mounting screw pilot holes.
( ) ( )
HOUSING CUTOUT
#8/ 4.166 mm
WOODSCREW
PILOT
.343"
8.71mm
CENTER OF HOUSING
.53"
6.187" 157.15 mm
HEIGHT OF HOLE
13.46mm
8.71mm
#8/ 4.166 mm
.343" WOODSCREW
PILOT
12.95mm
.510"
2. Use a screwdriver or pliers to unlock the the door springs from the
door.
3. Remove the four housing screws.
2
( ) ( )
Service Fax: 920.459.5462
Please read bottom clearance requirements below.
#8/ 4.166 mm
WOODSCREW
PILOT (4 PLACES.)
.343"
8.71mm
2.365" 60.07mm
3.230"
82.04mm
2.906" 53.21mm
.53"
13.46mm
1.985" 50.42 mm
2.437"
61.9mm
8.71mm
.343"
#8 / 4.166 mm
WOODSCREW
PILOT
5.437" 138.10 mm WIDTH OF HOLE
4. Remove the housing by pulling forward and allowing the housing to
flex around the side edges of the open door.
5. Mount the LidSaver into your cabinet using the four #8 round head
wood screws.
6. Replace the housing.
7. Hook the door springs.
™
LidSaver In-Counter Lid Dispensers Operator's Manual