Publicidad
STEP 1
Uninstall the slide set by releasing
the Blum triggers and pulling the
drawer box from the slides
(See Figure A). Set slide set to the
side for future use.
STEP 2
Install the figure 8 brackets onto
the front of the drawer using the
screws that come with them
(See Figure B).
STEP 3
Install the cable carrier arm via the
(2) pre-drilled holes on the left side
of the organizer box using (2)
#8 x 3/8" pan head screws
(See Figure C).
STEP 4
Attach the (5) wire clamps and the
(5) 1/4"-14 x 1/2" screws onto the
arm. Screw in a wire clamp on the
first, third, and fifth hole on the
top left bar and screw a wire clamp
into the second and fourth hole
on the right bar (See Figure D).
Once the screws and clamps are in
place, lift each clamp including the
clamp in the back of the drawer
and feed the cord through them.
Depending on where the wall
outlet is installed in the actual
cabinet; there will be slack in the
cord. This can be constrained by
the cord management system.
2
FIG. A
FIG. B
FIG. C
FIG. D
Customer Service: 800-626-1126 | rev-a-shelf.com
1st 3rd
5th
2nd
4th
Publicidad
