Publicidad
STEP 5
Attach the cable carrier bracket to
the LEFT Blum slide by unscrewing
the (2) screws that are already in
the bracket. Secure outside of the
slide for face frame and inside of
the slide for frameless
(See Figure E).
INSTRUCTION FOR
ATTACHING SLIDES AND
INSTALLING THE DRAWER
STEP 6
FACE FRAME ONLY
Note: For frameless application,
skip to Step 8.
Using the measurements from
the drawing, attach the rear Blum
brackets to the back of the cabinet
using (4) #8 x 5/8" wood screws
for each bracket.
Place (2) screws in the top row in
each of the two corners and place
(2) screws in the fourth row as
indicated by the dark circles
(See Figure F).
STEP 7
FACE FRAME ONLY
Using a 1/8"drill bit, pre-drill slide
mounting holes 13/32" from the
front edge of the cabinet. Attach
the (2) 1/8" Blum spacers to both
of the slides. Attach them to the
1st holes on each side. They will
clamp down on the top of each
slide (See Figure G-1). Place the
slide set on the rear brackets.
Then screw the slides set into the
cabinet (See Figure G-2 & G-3).
Note: If this step is installed
incorrectly, the organizer will not
travel smoothly on the slides.
Make sure to install the slide set
level in the cabinet.
#2
FIG. E
Face frame
FIG. F
13/16"
(21mm)
(3.2mm or 6.4mm)
FIG. G-1
INSTALLATION INSTRUCTIONS: VANITY OUTLET ORGANIZER
Frameless
13/16"
(21mm)
9/16"
(14mm)
+
1/8" or 1/4"
Spacer Width
FIG. G-2
FIG. G-3
13/32"
13/32"
3
Publicidad
