Kohler K-1665 Guia De Instalacion página 8

Glass Lens
Mounting
Prongs
Light
Install glass lens here.
Carrier
5. Complete the Installation - Both Styles
WARNING: Risk of burns. The glass dome may reach
temperatures of 300°F (149°C) when in use. Do not touch the
glass dome until it has cooled.
CAUTION: Risk of product damage. Avoid touching the
halogen light directly. Direct contact with skin can deposit oil
on the bulb surface, causing the bulb to burn out.
Install the finished ceiling.
Make sure the trim ring is securely seated on the light carrier.
Slide the glass lens into place in the opening under the prongs.
NOTE: Use a 12 V MR-16 buld, 50 W maximum with this light
fixture.
Slide the bulb into the mounting prongs. The bulb should rest
against the glass lens when properly positioned.
Pull the wiring down the light fixture.
Plug the bulb into the ceramic light socket.
When construction adhesive has finished curing, push the light
carrier up into the light carrier receiver.
Restore the power at the circuit breaker.
1015878–2–B
Bulb
8
Light
Carrier
Kohler Co.