Tabla de contenido
Publicidad
A - Lift radiant plate up & out of left slot.
B - Remove by sliding it out of right slot.
C - Remove burner screw and remove burner. Check burner for grease residue
or spider webs that may obstruct gas flow. CAUTION: WHEN REPLACING
BURNER, CUT SLOTS IN BURNER MUST FACE DOWN.
D - Lift the two-section liner out of outer shell by lifting up on the burner
support bracket on the left liner section. (1) Slide the left section partially
over the right section. (2) Grab the back of the left liner section and pull it
toward you until it clears the lip of the outer shell. (3) Lift liner section out
of grill.
E - Move the right liner section slightly to the left (1). Grab the back of this
section and pull it toward you (2) - lift and remove this section (3).
• Inspect burner, remove any obstructions.
• Clean as indicated in Maintenance (page 6).
• To re-assemble, reverse the procedure above.
Left
side
slot
Burner screw
A
D
DISASSEMBLY & RE-ASSEMBLY
B
2
3
1
Burner
support
bracket
1
E
5
Burner screw
C
2
3
Burner
Publicidad
Tabla de contenido
