Tabla de contenido
Publicidad
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS
• Magma On-Board LPG (Propane) Valves
and Hose Kits allow Magma Grills to be
installed within a boats existing on-board,
pre-regulated low pressure LPG (Propane)
system.
• Use only Magma Type 3 Low
Pressure LPG (Propane) Valves. See
our Valve Application Guide at www.
MagmaProducts.com for correct valve.
• In North America use Magma A10-225
LPG 10' Hose Kit in conjunction with
Type 3 Valve. Outside North America check
your local dealer for proper hose and fittings.
• A primary shutoff valve (supplied with
A10-225 hose kit) must be used with this
control valve at point of connection into
your system. This allows shut off of gas
supply to hose leading to grill.
• DO NOT CONNECT A HIGH-PRESSURE SUPPLY HOSE
FROM A NON-REGULATED TANK DIRECTLY TO GRILL.
Magma's grills are designed for use with small disposable propane canisters or with pre-
regulated low-pressure propane and optional low-pressure valves. Running high-pressure
propane fuel supply lines on a boat is in violation of American Boat & Yacht Council (ABYC)
guidelines and is not considered a safe application. Additionally, impurities found in larger
refillable propane tanks may clog the small orifices in the high-pressure control valve/
regulator causing it to lose performance capabilities and eventually fail. Regulating these
tanks to 1/2 PSI and using this pre-regulated propane with the correct low-pressure valve
will insure safe, efficient performance of the grill.
Connoisseur
Gas Grill
Insert valve as shown in diagram above. Valve
may seem loose, this is OK. Valve does not have
to be snug-fitting to be safe or function properly.
Typical Marine &
R.V. Application
Cylinder Valve
Gauge
Gas Regulator
Propane (LPG)
IMPORTANT!!
6a
Connoisseur
Gas Grill
Align valve stem key
to valve chamber
lock detent and rotate
Connoisseur
Gas Grill
Solenoid
Shut off
To other LPG
valve
appliance
or use cap
A10-225
Hose Kit
Type 3
Valve
Type 3
Valve
Publicidad
Tabla de contenido
