H.Koenig OptiV8 Manual De Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
Auto-cleaning function
A lot of incrustation is left in the steam dome after using a long time. The steam holes will be blocked when there are too much
incrustation. Soleplate needed to be washed after
10-15 times of using the water tank.
1. Filling water into water tank and plugging in.
2. Preparing a large basin, carrying the iron horizontally above the basin.
3. Pressing the "SETTING" button 3 seconds, pump will be started to work, the "CLEAN- ING"light
blinking.
4. The iron will be heated and washed automatically after pumping, then a lot of hot water flow out
through the steam holes with cleaning the incrustation at the same time. Until there is no any water
and steam, turn off the iron for cooling.
5. Use a wet cloth to wipe up the soleplate after cooling.
Note : if you want to stop the iron during the cleaning press the "setting" button

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido