Preparing The Appliance; Cleaning And Maintenance - Ghibli & Wirbel ASL 10 Instrucciones De Uso Y Mantenimiento

TYPE OF USE
This appliance has been designed to vacu-
um liquids as per the technical data table in
the introductory part of the manual. Only for
these uses I was conceived.
DANGER:
The manufacturer can not be
held responsible for any dam-
age due to improper or incor-
rect use.
Any other use releases the
manufacturer from liability for
harm to persons and/or proper-
ty and invalidates any warranty
condition.
IMPROPER USE
Do not use the appliance to:
- Aspirate flammable, explosive, corrosive
and toxic substances.
- Aspirate hot substances.
- Do not use the appliance in liquid suction
mode to suction powder and vice versa.
Do not use the appliance in areas at risk of
explosion.
PREPARING
THE APPLIANCE
Starting up the appliance
- Check that the plug (1 Fig. 1) is in the
socket (2 Fig. 1) of the steam production
machine.
- Press the switch (3 Fig. 2) to position "I"
to start the vacuum engine.
NOTES:
When the recovery tank is full, the noise
intensity increases and the device can no
longer aspire. Then you must switch off the
device and empty the tank as described in
the relevant paragraphs.
Switching off the appliance
- Push the switch (3 Fig. 2) to the "0" posi-
tion to stop the device.
CLEANING AND
MAINTENANCE
DANGER:
Before performing any main-
tenance operation, unplug the
appliance from the electrical
socket.
Emptying the recovery tank
- Disconnect the plug (1 Fig. 1) from the
socket (2 Fig. 1) on the steam production
machine.
- Unhook the sealing belt and disassemble
the wet vacuum cleaner from the steam
production machine.
- Release the lever (4 Fig. 3) and remove
the top (5 Fig. 4) along with the engine.
- Place it on the top of a drain and empty
the liquid in the recovery tank (6 Fig. 5).
- Clean the inside of the tank with running
water and then re-install everything doing
the opposite of the disassembly.
ENGLISH - 4
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968