Descargar Imprimir esta página

Panasonic SC-HCC40 Instrucciones De Funcionamiento página 5

Sistema estéreo compacto

Publicidad

Idiomas disponibles

Idiomas disponibles

Notes on installation
== Before installation,
read the "Safety
precautions"
and "Wall mount instructions"
for correct installation.
== For optimal performance
and to prevent potential problems,
do not install this unit:
at locations
other than vertical walls.
near a sprinkler
or a sensor.
near high-voltage
lines or power sources.
near heating device.
at locations
where the unit is subject to vibration
or impact.
near sources of magnetism,
heat, vapor, airborne grease, etc.
at locations
where there may be water droplets (e.g. under an air conditioner).
== Do not install this unit under ceiling lights (e.g. spotlight,
halogen light, etc.).
Failure to do so may bend the cabinet or lead to damage caused by high heat.
== Use a proper installation
method
that suits the structure
and material
of the wall.
== Use a soft blanket or cloth to prevent damage
to the product or floor during installation.
== When tightening
screws,
make sure the screws
are not loosely=tightened
or overtightened.
== Secure a safe surrounding
area and pay attention to safety during installation.
== Panasenic
is not liable for incidental
or consequential
damages
resulting from improper installation
or operation.
=
Only a qualified
building contractor
shall instal_ or uninstall
this
unit.
Improper installation
may cause the unit to fall, resulting in injury.
To prevent injury, the unit must be securely
attached
to the wal_ in
accordance
with the installation
instructions.
Do not install the unit where it cannot support the load.
If the mounting
parts are not strong enough, this may cause the unit to
fall, resulting in injury.
Do not use installation
methods
other than instructed.
This may cause the unit to fall and be damaged,
resulting in injury.
Do net install the unit at locations
other than vertical wails.
This may cause the unit to fall and be damaged,
resulting in injury.
Take the safety factor for mounting strength
into account
(approx.
10 times the product weight).
Insufficient
strength will cause the unit to fall, resulting in injury.
The wall on which
the unit is to be attached to should be capable
of supporting
20 kg (44 lb.) per screw.
Insufficient
strength of the walls will cause the unit to fall in the long
run.
Do not disassemble
or modify the wall=mounting
hanger.
This will cause the unit to fall and be damaged,
resulting in injury.
Do not install this unit at humid or dusty locations, or locations
where airborne grease
or steam may come into contact with the
unit, or under an air conditioner
where water
may drip onto the
unit.
This may have negative impact on the unit, resulting in fire or electric
shock.
Secure enough space of more than 30 cm (11 3/le") above the
main unit and more than 10 cm (3 W16") on the left and right sides
respectively.
Keep space between the wall and rear of the unit
clear of obstructions.
Blocking the exhaust holes on the main unit may result in fire.
Use the designated
components
for installation.
Otherwise,
the main unit may fall and be damaged,
resulting
in injury.
Prevent the mounting
screws
or power cord from coming into
contact with metal
parts inside the wall during
installation.
Failure to do so may cause electric shock.
When removing the main unit, remove
the wall mounting
screws
as well.
Otherwise
the wall mounting screws may hit a person and lead to
injury.
Install the unit at a height where the USB port and operation
buttons
can be seen for safe operation.
Operating
at improper position
may cause the unit to fall and be
damaged,
resulting in injury.
_=!1 i ncluded accessories
*
Screw accessories
(RFAX1020)
>7 2 Fixing screws O
(XYN3+J10FJ)
>7 1 Safety holder
(RMKX1015)
Wall bracket
accessories
(RFAX1021)
>7 1 Wall bracket
(RGQX1004)
>7 Four=legged
cushions
(RKAX0028-K)
Keep all the intended accessories
out of reach of children to
prevent swallowing.
==Commercially
available
accessories
(not included)
- 2 Wall mounting
screws
O
-
1 Safety holder screw
Use screws with nominal diameter of 4 mm (5/32'q. which are suitable
to the material of the wall (e.g. wooo. steel, concrete,
etc,
m
5

Publicidad

loading