Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8. Reinstall the lower fascia - Aligning tabs in lower fascia with upper fascia. Reinstall the (2) Philips screws at outer ends of fascia, (1) per side and (5) plastic rivets.
9. Install cable ties - Using (2) cable ties provided, secure lower fascia to hitch cross tube by inserting cable tie through the three outer fascia push-pin rivet
attachment points and around hitch cross tube (see figure-3).
10. Raise muffler back into position- Reattach all rubber hangers removed in step 2. Remove the support for the exhaust.
11. Reinstall underbody panels- Using (3) push pin rivets and (3) hex nuts removed in step 1, both sides.
©2019 Horizon Global Americas Inc. - Printed in Mexico
Sheet 7 of 21
24990NP
9-12-19
Rev. A
Publicidad
Tabla de contenido
