Maintenance - Black Max BM801700 Manual Del Operador

If any detergent still remains in the soap tank:
 Lift the soap tank off the pressure washer.
 Empty any remaining detergent and rinse tank, if desired.
 Align holes on tank with pins on pressure washer and
press down securely to reseat tank on pressure washer.
USING PUMP PROTECTOR
See Figure 18.
Regular use of a commercially available pump protector
prolongs the life of the pressure washer by removing hard
water mineral deposits, lubricating pump seals and pistons,
and preventing freeze damage. Pump protector should be
added to the unit after every use and before storage. Pump
protector can be purchased at the retailer where you pur-
chased your pressure washer, or by calling customer service.
The instructions that follow are typical for adding pump pro-
tector but you should always verify the specific instructions
provided by the manufacturer of the pump protector used.
 Turn off the pressure washer motor and shut off the water
supply. Pull trigger to release water pressure.
 Disconnect garden hose and high pressure hose.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
All manuals and user guides at all-guides.com
OPERATION
 Unscrew threaded top from pump protector bottle and
 Remove bottle cap and attach threaded end of bottle
 Squeeze bottle to inject contents into pump.
 Pump is protected when the protector fluid exits the pump
MOVING THE PRESSURE WASHER
NOTE: Never lift or carry this product using the handle.
 Turn the pressure washer off.
 Tilt the machine toward you slightly until it balances on
 DO NOT attempt to move the unit by pulling on any of

MAINTENANCE

Page 15 — English
remove paper seal from bottle. Reinstall top on bottle and
tighten securely.
NOTE: The rubber seal should remain inside the threaded
top. If it comes out, be sure to replace before reinstalling
the top.
securely to pressure washer pump water intake.
outlet.
the wheels then roll the machine to the desired position.
Do not tilt forward or sideways when moving.
the hoses.
WARNING:
Before inspecting, cleaning or servicing the machine, shut
off motor, wait for all moving parts to stop, disconnect
unit from power supply, and pull trigger to release water
pressure. Failure to follow these instructions can result
in serious personal injury or property damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.