Using Your Vac & Steam - Electrolux Vac & Steam Guia Del Propietario

87909rev2_VacSteam.qxp:English
Using your Vac & Steam
The Electrolux Vac & Steam is designed for use on hard-surface floors such as ceramic, stone, marble, vinyl, linoleum,
and sealed hardwood. Do not use on unsealed wood floors. If uncertain, test in an isolated area such as a closet.
NOTE: Heat and steam may remove the sheen on waxed floors or on some no-wax floors. Check use and care
instructions from flooring manufacturer.
C A U T I O N
I
Be sure Vac & Steam is turned off and
unplugged before removing water tank.
I
Fill tank with clear water only. Do not use
chemicals, soap, detergent, or vinegar.
I
Never use Vac & Steam without cleaning pad.
I
Always direct steam away from yourself. Never
direct steam toward people, animals, or plants.
I
Be sure dust cup and filter are in place. Slide latch
all the way right, to 'lock' position (Fig.1).
I
Place cleaning pad on floor with Velcro loop strips
facing up. Set floor nozzle onto pad (Fig. 2).
I
Remove cap and fill tank with tap water. Do not
exceed maximum fill line (Fig. 3). In areas with hard
water, use distilled water for better performance.
I
Plug in and press steam 'on' switch (Fig. 4). Allow
about 15 seconds for unit to produce steam.
I
Press down front of clean burst pedal to
'floor mop' position. Press vacuum 'on' switch
(Fig. 5). Use for light vacuuming, on hard
surfaces only.
I
Hold down floor nozzle and pull handle back
to comfortable angle for using (Fig. 6).
I
If desired, use vacuum and steam functions
separately.
Do not leave Vac & Steam standing on the
floor for any length of time while damp
cleaning pad is still on it. If you notice a whitish
'halo' on the floor surface, it can be removed
with a few drops of vinegar
(Do not put vinegar in water tank).
2 4
www.electroluxappliances.com
10/15/13 3:08 PM Page 6
Fig 1
Fig 3
applied to the floor.
Fig 5
Fig 2
Mop
Fig 4
Mop
Vac
Fig 6
Vac