MrHeater 1008ST-24-102 Instrucciones De Ensamblaje, Cuidado Y Uso página 11

TROUBLESHOOTING
PROBLEM
Power cord gets warm
to the touch.
Remote control does
not work.
Remote control
signal is weak and only
works sometimes.
Fan motor continues
to blow after unit is
powered of.
POSSIBLE CAUSE CORRECTIVE ACTION
Normal operation.
Weak or failing
battery.
Pressing the buttons
too quickly.
Using the remote
control too far away
or at an off angle.
Normal operation.
This is normal for a heater appliance as it requires
more current to operate. Check the connections of
the appliance cord and the outlet. Make sure the
plug and outlet frequently to determine if it is HOT;
if so, discontinue use of the appliance and consult
overheating outlet(s).
Replace with a new battery. (See page 9
for more information.)
Press the buttons slowly and steadily to ensure the
transmitter recognizes the request.
Move closer to the insert; the remote control will only
work within a distance of 20 feet and 45 degrees to
either side from the front of the heater.
This is a standard feature; the blower runs for
additional time to cool off the heater tubes.
11