Continuity Measurement; Diode Test; Battery Test - C-LOGIC 520 Manual De Instrucciones

C-LOGIC 520

3.3.5 Continuity Measurement

• Disconnect power from the circuit. Allow all capacitors to discharge.
• Set the thumbwheel to the continuity position.
• Connect the cables to the circuit being tested. If the measured resistance is
less than 50Ω, the buzzer will sound.
WARNING
To avoid injury or damage to the multimeter, disconnect power from the
circuit and completely discharge all capacitors in the circuit before making
resistance measurements.

3.3.6 Diode test

• Disconnect power from the circuit. Allow all capacitors to discharge.
• Set the thumbwheel to the diode position.
• Connect the red test lead to the input socket and the black lead to the COM
socket.
• Connect the red test lead to the anode (+) and the black test lead to the
cathode (-) of the diode and read the measurement on the display. The meter
will display "OL" if the connection is reversed.
WARNING
To avoid injury or damage to the multimeter, disconnect power from the
circuit and completely discharge all capacitors before performing diode
measurements.

3.3.7 Battery test

• Set the thumbwheel to the appropriate battery test range.
• Connect the red test cable to the input terminal and the black cable to the
COM terminal.
• Connect the red test lead to the positive (+) end and the black cable to the
negative (-) end of the battery and read the measurement on the display.
WARNING
To avoid injury or damage to the multimeter, do not connect it to a battery with
a nominal voltage greater than 60V AC or 30V DC.
- 21 -
EN