Start-Up / Operation; Connecting The Pumpset - Ardo CALYPSO Instrucciones De Uso

4. Start-up / Operation

4.1 Controls
Stand-by switch
4.2 Preparing the pump for use
Outlet operation:
• Insert the unit plug (h) of the power adapter (g) into the
electrical connection socket (i) of the unit (Fig. 1). The power
adapter must correspond to the local electricity supply.
Important: remove the batteries before plugging the unit into
the outlet.
Battery operation:
• Release the latch (Fig. 2) and slide open the battery cover.
• Six LR 06 / AA batteries are required for use. Check the
+ / - mark orientation of the batteries (Fig. 3).
• Close the battery compartment cover and secure by re-engag-
ing the latch (Fig. 4). The average working life with a medium
vacuum and cycle setting is approximately 5 hours (Duracell
batteries). We recommend that you use Duracell batteries.

Connecting the Pumpset

The Pumpset is an applied part of Calypso. Use of the Pumpset
(b) is detailed in the separate "Ardo Pumpset" instructions for
use.
• To use the single Pumpset: attach the tube connector (c) to
the pump (f) (Fig. 5). The second opening of the tube connec-
tor remains closed.
• To use the double Pumpset: Open the second opening of the
tube connector and attach the second Pumpset (Fig. 6).
• Attach the tube connector (c) to the pump (f) (Fig. 7).
4.3 Operation
The vacuum (suction strength) and cycle (suction speed) can be
adjusted independently of each other. Pressing the switches changes
the vacuum or the cycle by one level.
• Turn on the pump by pressing the stand-by switch (Fig. 8). The
green LED display will light up. Choose the settings which you
find most comfortable.
• Press the up-arrow to increase the vacuum (suction strength).
Press the down-arrow to reduce the vacuum (Fig. 9).
• Press the up-arrow to step-up the cycle (suction speed). Press the
down-arrow to reduce the cycle (Fig. 10).
Questions: visit www.ardo-usa.com or call us at 844-411-ARDO (2736)
Adjust the vacuum (V)
Adjust the cycle (C)
1
3
5
8
en
2
4
6
7
9
10
5