TFA 35.1084.IT Manual De Instrucciones página 61

POSITIONING THE TEMPERATURE TRANSMITTER:
The transmitter is supplied with a holder that may be attached to a wall with
the two screws supplied. The transmitter can also be position on a flat
surface by securing the stand to the bottom to the transmitter.
To wall mount:
1.
2.
Note:
Before permanently fixing the transmitter wall base, place all units in the
desired locations to check that the outdoor temperature reading is receivable.
In event that the signal is not received, relocate the transmitters or move them
slightly as this may help the signal reception.
Secure the bracket onto a desired wall using the screws and plastic
anchors.
Clip the remote temperature sensor onto the bracket.
60