Hilti SFC 18­A Manual Del Usuario página 10

5.11 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
6 Troubleshooting
6.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The power tool does not
work.
The power tool does not work
and one LED flashes.
The on/off button cannot be
pressed, i.e. the button is
locked.
LED 1 flashes
The battery runs down more
quickly than usual.
The battery does not engage
with an audible double click.
6
Printed: 27.07.2016 | Doc-Nr: PUB / 5293248 / 000 / 00
4
Possible cause
The battery is not fully inserted.
Low battery.
Electrical fault.
Low battery.
The battery is too hot or too cold.
The forward/reverse selector
switch is in the middle position.
Low battery.
The tool is overloaded (application
limits exceeded).
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Action to be taken
▶ Push the battery in until it
engages with an audible double
click.
▶ Change the battery and charge
the empty battery.
▶ Remove the battery from the
tool and contact Hilti Service.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended operating temperature.
▶ Push the forward/reverse switch
to the left or right.
▶ Change the battery and charge
the empty battery.
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See the "Technical
data" section.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.