Honeywell HEPA CLEAN HHT-149-HD Manual De Instrucciones página 6

HHT-149-HD_OM.qxd
CLEANING/REPLACING THE HEPA-TYPE FILTERS (CONTINUED)
These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon
the concentration of contaminates going through the system. High concentrations of contaminates
such as smoke will reduce the useful performance of the filter.
NOTE: The HEPA-Type filters are not washable.
To Replace Your HEPA-Type Filters:
You can purchase Honeywell replacement HEPA-Type filters
the filters vs. cleaning them. Replacement
store or can be ordered directly at www.homedepot.com. If you have any questions, contact Kaz
Consumer Services at 1-800-447-0457.
FILTER INSTALLATION INSTRUCTIONS
• Air purifier should be turned OFF, and unplugged prior to replacing filters.
• Remove the rear grille from the air purifier by pushing down on the
release tab at the top of the rear grille and pulling the grille away from
the unit (Fig 9).
• Remove protective wrap from filter(s).
• Note the arrows on the filter frame – snap new filters into place with the
arrows facing toward the unit. Install bottom filter first, then top filter. Filters
must snap in place in order for the unit to operate properly.
• Re-install the rear grille by inserting the lower tab of the grille into the tab
slot near the bottom of the air purifier. Push the top into place until you hear
a "snap" (Fig 10).
• Plug unit back in. Unit is ready for use.
replacement filters may be available from the Home Depot store where you
purchased your air purifier, or can be ordered directly from Home Depot at
www.homedepot.com.
If you have any questions, contact Kaz Consumer Services at 1-800-477-0457.
3/4/10 9:44 AM Page 6
HEPA-Type filters may be available at your local Home Depot
for your air purifier if you prefer to replace
Fig. 9
Fig. 10