Connecting To Devices; Connection Guidelines - Intel Express 535T Guía De Inicio Rápido Y Del Usuario

Connecting to Devices

Connection Guidelines

General
• The copper ports of the 535T switches are capable of autonegotiating
port speed and can operate at 10Mbps or 100Mbps per port. The switch
matches the highest possible speed of an attached device.
• The 535T's fiber modules always operate at 100Mbps.
• The 535T switches are capable of autonegotiating port duplex and can
operate at half- or full-duplex.
• Configure the network so devices that talk primarily to each other are
on the same segment. Each port is a single segment.
Cabling
• Use Category 5 unshielded twisted-pair (CAT 5 UTP) cable when
connecting 100Mbps devices to the switch.
• Use Category 3, 4, or 5 unshielded twisted-pair (CAT 3, 4, or 5 UTP)
cable when connecting 10Mbps devices to the switch.
• Limit the cable length between devices to 100 meters (328 feet).
• Use a straight-through cable to connect the switch to a server or
workstation. For more information on cabling, see "Cabling Devices."
• To connect to another switch or hub use crossover cables.
• To connect a device to one of the fiber ports, use 62.5/125 µm
multimode cabling. This cabling can be a maximum of 2,000m when
operating at full-duplex, and 160m (to a hub) or 400m (to a router,
switch, or PC) when operating at half-duplex.
19