Regulatory Information and Warnings
FCC Part 15 Compliance Statement
This product has been tested and found to comply with the limits for
a Class A digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment.
This product generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning this equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
· Change the direction of the radio or TV antenna.
· To the extent possible, relocate the radio, TV, or other receiver
away from the product.
· Plug the product into a different electrical outlet so that the
product and the receiver are on different branch circuits.
If these suggestions don't help, consult your dealer or an
experienced radio/TV repair technician for more suggestions.
NOTE This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
CAUTION If you make any modification to the equipment not
expressly approved by Intel, you could void your authority to
operate the equipment.
Canada Compliance Statement (Industry Canada)
Cet appareil numérique respecte les limites bruits radioélectriques
applicables aux appareils numériques de Classe A prescrites dans la
norme sur le matériel brouilleur: "Appareils Numériques",
NMB-003 édictée par le Ministre Canadien des Communications.
This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus set out in the
interference-causing equipment standard entitled: "Digital
Apparatus," ICES-003 of the Canadian Department of
Communications.
Manufacturer Declaration
®
This certifies that the Intel
Express 535T Switch complies with the
EU Directive 89/336/EEC, using the EMC standards EN55022
(Class A) and EN55024. This product also meets or exceeds EN
60950 (safety) requirements. These products have been tested and
verified to meet CISPR 22 Class A requirements.
Australia Statement
26
Taiwan Class A EMI Statement
VCCI Statement
Class A ITE
This is a Class A product based on the standard of the Voluntary
Control Council for Interference by Information Technology
Equipment (VCCI). If this equipment is used in a domestic environ-
ment, radio disturbance may arise. When such trouble occurs, the user
may be required to take corrective actions.
Warnings
WARNING
This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures. Internal access to Intel
intended only for qualified service personnel. Do not remove any
covers.
WARNING
The system is designed to operate in a typical office environment.
Choose a site that is:
· Clean and free of airborne particles (other than normal room
dust).
· Well ventilated and away from sources of heat including direct
sunlight.
· Away from sources of vibration or physical shock.
· Isolated from strong electromagnetic fields produced by
electrical devices.
· In regions that are susceptible to electrical storms, we
recommend you plug your system into a surge suppressor and
disconnect telecommunication lines to your modem during an
electrical storm.
· Provided with a properly grounded wall outlet.
Do not attempt to modify or use the supplied AC power cord if it is not
the exact type required.
Ensure that the system is disconnected from its power source and from
all telecommunications links, networks, or modems lines whenever the
chassis cover is to be removed. Do not operate the system with the
cover removed.
®
Express 535T Switch is