Install The Hardware - Axis F Serie Guia De Instalacion

AXIS F41 Main Unit

Install the Hardware

The Axis F41 Main Unit can be placed on a table desktop or mounted on
a DIN rail. To facilitate routing the cables from the top or side remove
the 4 screws (Torx T20) and suitably realign the bottom plate under the
unit (see Hardware Overview on page 10). See www.axis.com for optional
accessories.
1. If required, press to release the dummy SD card and insert an
SD memory card in the SD memory card slot.
2. Attach the network cable to connect the unit to the network.
3. Connect the sensor unit to the main unit with the RJ12 cable.
4. If required, connect an AC/DC power supply to the power
connector.
5. If required, attach the I/O cable using the 6–pin I/O connector
block to connect external input/output devices.
6. If required, attach the audio cables to connect an active
speaker/external microphone.
20