Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.1. ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the plug
in any way. Using original plugs and matching sockets
reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes,
heaters, boilers and refrigerators. There is an increased
risk of electric shock if the earthed device is exposed
to rain, comes into direct contact with a wet surface or
is operating in a damp environment. Water getting
into the device increases the risk of damage to the
device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it
to carry the device or to pull the plug out of a socket.
Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables
increase the risk of electric shock.
e)
If working with the device outdoors, make sure to use
an extension cord suitable for outdoor use. Using an
extension cord suitable for outdoor use reduces the
risk of electric shock.
f)
If using the device in a damp environment cannot be
avoided, a residual current device (RCD) should be
applied. The use of an RCD reduces the risk of electric
shock.
g)
Do not use the device if the power cord is damaged
or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or
the manufacturer's service centre.
h)
To avoid electric shock, do not immerse the cord, plug
or device in water or other liquids. Do not use the
device on wet surfaces.
2.2. SAFETY IN THE WORKPLACE
a)
Make sure the workplace is clean and well lit. A messy
or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive
environment, for example in the presence of
flammable liquids, gases or dust. The device generates
sparks which may ignite dust or fumes.
c)
If you discover damage or irregular operation,
immediately switch the device off and report it to
a supervisor without delay.
d)
If there are any doubts as to the correct operation of
the device, contact the manufacturer's support service.
e)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
f)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
g)
Children or unauthorised persons are forbidden to
enter a work station. (A distraction may result in loss
of control over the device).
h)
Use the device in a well-ventilated space.
i)
Only connect and disconnect the pressure line when
the air valve is closed.
j)
Do not point the pressure line towards yourself or
toward other people or animals.
k)
Do not cut off the supply of compressed air by
crushing or bending pressure hoses.
l)
Regularly inspect the condition of the safety labels. If
the labels are illegible, they must be replaced.
m)
Please keep this manual available for future reference.
If this device is passed on to a third party, the manual
must be passed on with it.
10
n)
Keep packaging elements and small assembly parts in
a place not available to children.
o)
Keep the device away from children and animals.
p)
If this device is used together with another equipment,
the remaining instructions for use shall also be
followed.
q)
Ensure adequate ventilation where the device is
used. The gases processed by the device can displace
breathable air.
r)
There is a risk of inhaling harmful gases or vapours in
the place where the device is used.
REMEMBER When using the device, protect
children and other bystanders.
2.3. PERSONAL SAFETY
a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which can
significantly impair the ability to operate the device.
b)
The machine is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience and/
or knowledge unless they are supervised by a person
responsible for their safety or they have received
instruction on how to operate the machine.
c)
When working with the device, use common sense
and stay alert. Temporary loss of concentration while
using the device may lead to serious injuries.
d)
Use personal protective equipment as required
for working with the device, specified in section 1
(Legend). The use of correct and approved personal
protective equipment reduces the risk of injury.
e)
To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
f)
Do not overestimate your abilities. When using the
device, keep your balance and remain stable at all
times. This will ensure better control over the device
in unexpected situations.
g)
Compressed air may cause serious injury.
h)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
2.4. SAFE DEVICE USE
a)
Do not overload the device. Use the appropriate tools
for the given task. A correctly-selected device will
perform the task for which it was designed better and
in a safer manner.
b)
Do not use the device if the ON/OFF switch does not
function properly (does not switch the device on and
off). Devices which cannot be switched on and off
using the ON/OFF switch are hazardous, should not
be operated and must be repaired.
c)
Disconnect the device from the power supply
before commencement of adjustment, cleaning and
maintenance. Such a preventive measure reduces the
risk of accidental activation.
d)
When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
e)
Keep the device in perfect technical condition. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
Rev. 25.09.2019
f)
Keep the device out of the reach of children.
g)
Device repair or maintenance should be carried out by
qualified persons, only using original spare parts. This
will ensure safe use.
h)
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
i)
When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country
where the device will be used.
j)
Avoid situations where the device stops working
during use due to excessive loading. This may result
in overheating of the drive elements and damage to
the device.
k)
Do not leave this appliance unattended while it is in use.
l)
Clean the device regularly to prevent stubborn grime
from accumulating.
m)
At locations where there is a high risk of mechanical
damage, use a reinforced hose for compressed air
connections.
n)
Do not carry or hang the device by the pressure line.
o)
The device is not a toy. Cleaning and maintenance may
not be carried out by children without supervision by
an adult person.
p)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
q)
Keep the device away from sources of fire and heat.
r)
Follow local OHS and electrical equipment regulations.
s)
Do not step on the device or use it as a support.
t)
Before each use, check the compressed air system and
electrical components for signs of damage or leakage.
Defective components must be repaired or replaced
before working with the device.
u)
Check at regular intervals that all connectors and
screws are properly tightened.
v)
Parts of the device may be hot for some time after the
machine is turned off.
w)
Keep your fingers away from the working device. The fast
moving and hot parts may cause injuries and / or burns.
x)
If the device starts vibrating excessively, stop the
engine and immediately check the cause. Vibration is
usually a fault signal.
y)
To reduce the risk of fire, protect the engine / housing
from oil, solvent or excessive lubrication.
z)
Never remove or attempt to adjust the safety valve.
Protect the safety valve against paint or any deposits.
aa)
Never attempt to repair or modify the tank! Welding,
drilling or any other modification will weaken the
tank, making it susceptible to damage due to rupture
or explosion. It is mandatory to replace worn or
damaged tanks.
bb)
Drain the fluid from the tank after each use of
the machine. The tanks rust due to moisture
accumulation, which ultimately reduces their strength.
The tank should be emptied regularly and periodically
checked for corrosion.
cc)
The movement of pressurized air may cause dust
and dirt to accumulate, which may be harmful. When
removing moisture or decompressing the compressor
system, remove air slowly.
dd)
Do not spray flammable materials in the vicinity of an
open flame, sparking or glowing objects.
ee)
Do not smoke when spraying paint, insecticide or
other flammable substance.
Rev. 25.09.2019
ff)
When spraying, use a mask and provide adequate
ventilation of the workplace to prevent health and
fire hazards.
gg)
Do not aim paint spray or other sprayed materials at
the device. Position the device as far as possible from
the spray area.
hh)
When spraying or cleaning with solvents or toxic
chemicals, follow the instructions provided by the
chemical manufacturer.
ii)
To avoid the risk of severe burns, never touch the
delivery pipe. It gets very hot during use.
jj)
Hoses connected to the device should be reinforced.
kk)
Only use hoses and connectors capable of withstanding
the maximum pressure generated by the machine.
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there
is still a slight risk of accident or injury when using
the device. Stay alert and use common sense when
using the device.
3. USE GUIDELINES
The oil-free compressor is designed to supply other
pneumatic equipment and tools with compressed air free
of oil contaminants. The compressed air from this device
contains moisture. If dry air is required install a water filter
or air dryer. Without appropriate additional devices, this
machine cannot be used to supply air of a quality suitable
for breathing by living beings.
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
MSW-0AC550-8L
3
MSW-0AC750-8L
1
2
4
5
6
9
7
8
MSW-0AC550-24L
MSW-0AC750-24L
2
1
4
3
6
10
11
12
5
9
7
8
11
Publicidad
Tabla de contenido
