Heath Zenith SL-6155 Serie Manual De Instalación página 2

The chime can be mounted vertically
or horizontally (depending on model)
using 2 holes in back of case, or using
one keyhole and one mounting hole. It
is highly recommended to use at least
two mounting screws with anchors.
It is recommended to secure
chime to wall using screws and
anchors through both holes.
Note: Model SL-6250 is packaged as a set. Mount shelf using keyholes on
rear of unit and 2 large screws provided.
Warning: Model SL-6250 may be used as a shelf and has a load rating of
5 lbs. (2.25 kg). All other chimes are not load rated.
Note: Most installations will not require you to change any jumpers on
your chime and push button.
The push button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the push button and chime. The
code is factory set; however, there are 128 selectable codes that allow you
to expand your system and prevent outside interference. Other wireless prod-
ucts may cause interference and the system may not function properly. Fol-
low the instructions below for setting a new code.
1. Open the cases and locate the jumpers on both the push button and chime
(See illustration on page 3).
2. The push button and chime both have eight different jumper locations.
The jumper positions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if
system is functioning properly. Note: Jumpers in positions 1 through 7
must be exactly the same for both the push button and chime for this
system to function.
Snap cover onto
chime as shown.
Code and Tune Settings
Code Settings
Pry with a small screwdriver to
remove case before installing.
To remove cover after base is
mounted, firmly grasp cover and
pull.
-2-
Keyholes
598-1000-05