English; Key And General Notes; Electric Shocks; Warnings - DAB M/T 1.0 Instrucciones Para La Instalacion Y Mantenimiento

1.1

KEY AND GENERAL NOTES

WARNINGS FOR SAFETY OF PERSONS AND OBJECTS
The meanings of the symbols used in this manual are provided below
Read this documentation carefully before installation. Installation and operation must comply with the
safety regulations in force in the country in which the product is installed. The entire operation must be
carried out in a workmanlike manner.
Failure to comply with the safety regulations not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
1.2

WARNINGS

1.2.1 Skilled personnel

It is advisable that installation be carried out by competent, skilled personnel in possession of the
technical qualifications required by the specific legislation in force.
The term skilled personnel refers to persons whose training, experience and instruction, as well as their
knowledge of the respective standards and requirements for accident prevention and working conditions, have
been approved by the person in charge of plant safety, authorizing them to perform all the necessary activities,
during which they are able to recognize and avoid all dangers. (Definition for technical personnel IEC 60634)

Safety

1.2.2 Safety
Use is admitted only if the electric system implements all safety precautions in accordance with the
regulations in force in the country where the product is installed (for Italy, IEC 64/2).
From hereon, for reasons of simplicity, all inverters referred to in this manual will be named ACTIVE
DRIVER, when all features are common to all versions.

1.2.3 Responsibility

The Manufacturer does not vouch for correct operation of the ACTIVE DRIVER or for any damage that it
may cause if it has been tampered with, modified and/or run outside the recommended work range or in
contrast with other indications given in this manual. The Manufacturer declines all responsibility for possible
errors in this instructions manual, if due to misprints or errors in copying. The Manufacturer reserves the
right to make any modifications to products that it may consider necessary or useful, without prior notice and
without affecting the essential characteristics.

1.2.4 Special warnings

Before working on the electrical or mechanical part of the system, always turn off the mains voltage.
Wait at least five minutes after the power supply to the machine has been switched off before opening
the appliance. The capacitor of the continuous intermediate circuit remains charged with dangerously
high voltage even after the mains voltage has been switched off.
Only firmly wired mains connections are admissible. The appliance must be earthed (IEC 536 class 1, NEC
and other relevant standards).
Mains and motor terminals may carry dangerous voltage even when the motor is stopped.
DANGER
Risk of physical injury or damage if instructions are not observed

ELECTRIC SHOCKS

Risk of electric shocks if instructions are not observed
Read this documentation carefully before installation.

ENGLISH

41
English