AB Quality 2706-PENET1 Instrucciones De Instalación página 12

12 InView Ethernet TCP/IP Module
However, upon successfully setting up the Gateway Address and Subnet Mask, the
following message will appear telling you to cycle power to the module.
After the IP Address, Gateway Address and Subnet Mask have all been established,
click the OK button on the bottom of the Ethernet TCP/IP Communications
window. This will allow the settings to be saved and configuration is now
complete.
Once the settings have been saved, they can now be viewed, by clicking on the
Advanced button located in the section titled TCP/IP settings on the Edit Display
window.
Publication 2706-IN008D-EN-P - October 2003