AB Quality 2706-PENET1 Instrucciones De Instalación página 6

6 InView Ethernet TCP/IP Module
TB1 Terminal
Block for serial
connection
Power Line
5. Mount the cable grip to the InView display housing. Tighten the locknut
finger-tight and rotate an additional 1/2 turn.
6. Connect the incoming serial wires to the TB1 terminal block.
TIP
7. Torque the cable grip until the cap is completely seated.
8. Replace the power supply back cover with the 6 screws. Torque the screws
to 2.7Nm (24 in-lbs).
9. Connect the power supply to a power source.
Publication 2706-IN008D-EN-P - October 2003
White (Rxd)
White / Black Line (Txd)
Black / White Line (PWR)
Black (GND)
Be sure to place the wires so they are not caught by screws
when replacing the power supply cover, and also so they do
not interfere with fan operation.
Insert the serial wires with
the cable grip into one of
these conduit openings.
TB1
Incoming serial wires
TB1 Terminal Block
(NC) 8
(NC) 7
(NC) 6
(NC) 5
(RS-232 RX) 4
(RS-232 TX) 3
(+5V) 2
(GND) 1