Wiring The Ethernet Tcp/Ip Module To The Inview Display - AB Quality 2706-PENET1 Instrucciones De Instalación

Customer-supplied
Ethernet through
NEMA-rated
supplied connector
Note: Loop Ethernet
cable inside enclosure to
relieve stress on the
communication card.

Wiring the Ethernet TCP/IP Module to the InView Display

1. Disconnect power to InView display.
ATTENTION
2. Remove the power supply cover by unscrewing its 6 screws. Set the screws
and cover aside for later step.
3. Feed the serial cable through the cable grip (shipped with module).
4. Insert the serial wires through the right conduit opening on either the top or
the bottom of the InView display.
Back of InView Display (P42, P43, P44)
2706-PENET1
NEMA Type 4X Enclosure with Removable Cover
Torque Enclosure Cover screws to 1.1 Nm (10.0
in-lb).
Hazardous voltage. Contact with high voltage may
cause death or serious injury. Always disconnect power
to sign prior to servicing.
InView Ethernet TCP/IP Module
Right conduit openings
Publication 2706-IN008D-EN-P - October 2003
To terminal block
inside power supply cover
on back of display
Serial cable to be connected
to InView display
5