Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Mounting the correct accessory
This tool is supplied with a set of accessories for different applications.
• Make sure that the tool is switches off and the nozzle has cooled down.
• Set the desired accessory onto the nozzle as the Fig. 2 shown.
Switching on and o
• To switch the tool on, slide the ON/OFF switch button (4) upwards
• To switch the tool off, set the ON/OFF switch button to position "O". Let the tool cool down before moving or storing it.
• You can select the desired air flow of this tool that there are there positions (I and II) on the ON/OFF switch button when
operating.

Switch Positions

Position I
Position II
Stripping paint
• Mount an appropriate accessory.
• Set a high air temperature.
• Switch the tool on.
• Direct the hot air onto the paint to be removed.
• When the paint softens, scrape the paint away using a scraper.
WARNING: Do not keep the tool directed at one spot too long to prevent igniting the surface.
WARNING: Avoid collecting paint on the scraper accessory, as it may ignite. If necessary, carefully remove paint debris from the
scraper accessory using a knife.
Temperature is 330˚C and the air flow is 300L/min
Temperature is 510˚C and the air flow is 450L/min
Fig. 2
Fig. 4

Publicidad

Tabla de contenido
loading

Tabla de contenido