2 . 2
AUTOMATIC HOSE REWIND
1) Put the gearbox lever in the working posi-
tion ( fig.24).
2) Increase the machine pressure slowly until
it reaches the operating pressure.
3) Select the gear with the lever of the gear-
box (fig.24)
Final speed is set by opening and closing the
by-pass (fig.25. This adjustment is carried
out by unscrewing the knob and blocking it
in the required position
MOD. G/F8
from 32.8 – 49.2 ft/hr
from 49.2 – 98.4 ft/hr
from 98.4 – 196.8 ft/hr
196.8 ft/hr
CAUTION: whenever the pumping system stops supplying water, the machine will stop and automatically starts working
again when the pressure is restored.
2.3 AUTOMATIC MACHINE STOP
When the hose is completely wound, the hose stopping hook pushes against the
lever (fig.26), and puts the gearbox automatically in the idle position 0, thus
stopping the hose winding. At the same time the water discharge valve and the
shut-off valve are operated for the automatic stopping in the pumping stations (if
the machine is equipped with one of these valves).
2.4 INSPECTIONS TO BE CARRIED OUT DURING START UP OPERATION
1) Check that the hose-guide fork is in the correct position (lined up with the hose
or slightly pressing it towards the already wound up loop).
This inspection must be carried out with the hose completely laid out.
To adjust the position of the hose-guide fork:
- take the protection guard of the reel side chain off (fig.27)
- open the connecting link of the chain, then rotate the hose-guide scroll bar to the
right or to the left until the hose-guide fork is in the correct position.
For safety reasons this operation must carried out when the machine is not
operative.
2) Check that the automatic disengaging system at the end of the stroke is adjusted.
Pushing manually on the automatic disengaging bar and check that the gearbox is
neutral. If the gearbox stopping lever is not properly adjusted, adjust it through the
screw (fig.28)
Fig.24
ESTIMATED SPEED PER GEAR SELECTION :
LEVER NR. 1
1
2
3
4
Fig.25
CAUTION: when changing gear make sure to decrease
the speed of the turbine using the appropriate lever or by
the computer, if any.
WARNING:. These instructions must be strictly respected
particularly when shifting from the third to the fourth
speed (gear).
Fig.26
Fig.27
Fig.28
GB
18