Installing The Ebode Ir Link C - Ebode IR Link Serie Guia Del Usuario

equipment with a remote room, your current hook-up should be similar to figure 1. If it isn't,
run a single length of RG59 or preferably RG6 cable from the Main Room to the Remote
Room.
NOTE: If RF amplifier(s), splitters or taps are used anywhere in the line of the coaxial cable
between the CPL Coupler and the INJ Injector, you must verify if those are DC passive in
order to be sure to route the IR commands through the amplifier(s) and splitters.

5. Installing the ebode IR Link C

INSTALLING THE IRLP IR RECEIVER
Insert the red mini plug attached to the
IRLP into the jack marked "IR RECEIVER"
on the INJ Injector. Refer to figure 2.
Plug the 12VDC Power Supply cord into
the jack marked "+12 V" on the INJ
Injector. Plug the power supply into a
230V~50Hz outlet after you have made
all other connections.
Position the IRLP IR Receiver so that the
InfraRed beam from the handheld
remote control has a direct view at the
front of the unit (within 10m). The
Receiver can be fixed to the surface
by using the double side tape pad or
via a slide on screw hole on the bottom of the unit.
INSTALLING THE INJ INJECTOR
Insert the "TO TV" plug on the back of the INJ Injector into "RF IN" on the TV in the Remote
Room. Connect the room-to-room cable to "ANT INPUT" on the INJ Injector.
INSTALLING THE CPL COUPLER
Insert the "SAT/VCR" plug on the back of the CPL Coupler into "OUT TO TV" on DVR in the
main room.
Connect the room-to-room cable to "REMOTE/TV" on the CPL Coupler, as shown in Fig. 2
INSTALLING THE 3IREDB TRIPLE IR EMITTER
Plug the 3IREDB Emitter into the jack marked "EMITTER" on the CPL Coupler in the main
room.
The emitters should be installed directly to the InfraRed sensor "window" on the front panel
of the satellite Receiver, DVR, cable box, etc. Simply remove the paper backing exposing
the adhesive surface of each Emitter and apply them to the centre of the sensor window.
NOTE: Although the IRED appears dark to the eye, it is transparent to InfraRed. Positioning
the IRED directly over the InfraRed window(s) of the component(s) will not block direct IR
control from a handheld remote.
ATTENTION: If you are only using one A/V appliance, then you do not need to use the
additional IR Emitters. Never remove it from the wire! Just dress up the wire and leave
close to the CPL.
10-8-2010 5 ebode IR LINK C