Setting Up Your Tower; Setting Clock; Setting Alarm; Sleep Mode - Bigben Interactive TW9 Manual De Instrucciones

Setting up Your Tower

5.
Attach the four pads to the base bottom
to protect the ground.(1PC for spare parts)
Power
Place the unit in the desired position and unravel the mains cable. Insert the cable into the
supply socket and switch on if applicable.

Setting Clock

After the unit is plugged into a mains supply or mains power failure, the
display will show the "0:00" on the LCD display. The unit should be in
standby mode to set the current clock.
1. Press TIME button, the digits for the display will blink.
2 .Press the PREVIOUS/NEXT button repeatedly until correct hour is set. Press the TIME
to confirm. The hour setting; the minute digits on the display will blink.
3. Press the PREVIOUS/NEXT button repeatedly until correct minute is set. Press the
TIME to confirm the minute setting.

Setting Alarm

Press and hold ALARM button in shutdown state, the display will flash ON/OFF to select
setting alarm or canceling alarm.
Press PREVIOUS/NEXT to select ON, and the display will blink.
Press PREVIOUS/NEXT button repeatedly to set hour. Press ALARM to confirm, then press
PREVIOUS/NEXT to set minute.
Press ALARM to confirm, and then press PREVIOUS/NEXT to select USB/SD/FM status.
Press ALARM to confirm.
When no USB is connected, the unit will change to SD/FM alarm automatically.
The volume would turn up from 0 to 25 gradually.

Sleep Mode

Press the SLEEP button, the display will blink. Press the button until the display shows the
minute you want to set. You can set 10 to 90 minutes.
It blinks three times to confirm, and then return to the interface before. If you want to cancel the
sleep mode, press to 00, after blanking three times, the sleep mode will cancel.
Remark:
In order to save energy when the unit has no sound output for a while, the unit will
to stand-by automatically. It can be
switched ON by using the function selector again.
- EN 4 -
be switched