Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE TEMPERATURE
CONTROL
•
The first time you turn the unit on, set the temperature control to "7" the coldest.
•
The range of the temperature controls are from position "0" or NO COOLING
to "7" the coldest. After 24 to 48 hours, adjust the temperature control to the set-
ting that best suits your needs. The setting of "4" should be correct for home or
office refrigerator use.
NOTE:
•
IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU
MUST WAIT 3 TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU
ATTEMPT TO RESTART BEFORE THIS TIME DELAY, THE
REFRIGERATOR-FREEZER WILL NOT START.
•
TURNING THE REFRIGERATOR TEMPERATURE CONTROL TO "0" POSITION
STOPS THE COOLING CYCLE BUT DOES NOT SHUT OFF THE POWER TO
THE UNIT.
INTERIOR LIGHT
When you open the door the light will be ON automatically. When you close the door the light will turn OFF
automatically.
DEFROSTING YOUR APPLIANCE
• When? For the most efficient operation and minimum energy consumption, defrost the freezer compartment when the frost on
the appliance walls is excessive or ¼ inch thick.
There is no need to defrost the refrigerator compartment, because ice depositing on the inner back wall is defrosted
automatically. Ice may deposit on the inner back wall during the compressor operation; later on, when the compressor is not
operating the ice will defrost and the water drops collect and drain through the outlet in the inner back wall into the drain pan
situated above the compressor, from where is evaporates.
• How?
Do not use boiling water because it may damage the plastic parts. In addition, never use a sharp or metallic instrument to
remove frost as it may damage the cooling coils and will void the warranty. We recommend using a plastic scraper.
• Reset the thermostat to the "0" position and disconnect the power supply.
• Remove the frozen food from the appliance and place it in a cooler to protect the food.
• Leave the door open for a while so that you can easily scrap off the frost.
• Use a plastic scraper but be careful not to damage the inner surfaces of the freezer.
• Wipe up the scraped off frost and ice before it is completely defrosted.
OPERATING INSTRUCTIONS
CAUTION
3
Publicidad
Tabla de contenido
