Programming Sections - Paradox Grafica DNE-K07 Manual De Referencia E Instalación

Use this section to copy Grafica sections [001] to [004], all zone labels,
area labels and user labels to the Memory Key.
Only the Memory Key will function with Grafica keypads.
1. Insert the Memory Key into the keypad's connector (Figure 9 on
page 39). Ensure that the Memory Key's jumper is ON (Figure 10 on
page 40).
2. To copy the contents to the Memory Key, enter the keypad's
programming mode (section 4.1 on page 5) and enter section [110] in
step 5.
3. After the confirmation beep, wait five seconds and remove the Memory
Key after the second confirmation beep.
After copying data, set the jumper to OFF to avoid accidentally
overwriting its contents (Figure 10 on page 40).
6.3 Updating Grafica's Firmware Version
Update Grafica's firmware version, without physically changing the
microprocessor, by using the Universal In-Field Programmer (UIP-256).
Connect the Universal In-Field Programmer to Grafica (Figure 9 on
page 39) and refer to the Universal In-Field Programmer Instructions to
update Grafica's firmware version.

7.0 Programming Sections

= Default Setting
Section [001]: Keypad Partition Assignment
Option
[1] P
ARTITION
[2] P
ARTITION
[3] P
ARTITION
[4] P
ARTITION
[5] P
ARTITION
[6] P
ARTITION
[7] P
ARTITION
[8] P
ARTITION
10 Reference & Installation Manual
1
2
3
4
5
6
7
8
OFF
D E
ISABLED
D E
ISABLED
D E
ISABLED
D E
ISABLED
D E
ISABLED
D E
ISABLED
D E
ISABLED
D E
ISABLED
ON
NABLED
NABLED
NABLED
NABLED
NABLED
NABLED
NABLED
NABLED