Function And Response Table; What To Expect During Use Of The Bark Control Collar - Petsafe PBC17-14036 Manual De Funcionamiento

Function and Response Table

Function
Unit is on
Emitting ultrasonic tone
Low battery condition
What to Expect During Use of the Bark
Control Collar
Important: Do not leave your dog alone the first few times he receives a correction.
Place the Bark Control Collar properly on your dog and wait nearby until he barks. Most dogs will
understand very quickly that the Bark Control Collar is disrupting their urge to bark and will relax and stop
barking. Because the ultrasonic correction from the Bark Control Collar may be surprising or startling at first,
some dogs may bark more at the initial correction.
On rare occasions, a dog may get into a bark-correction-bark-correction cycle. If this happens, reassure
your dog with calm, soothing tones. As your dog relaxes, he will understand that if he becomes quiet, he
will not receive any more ultrasonic corrections. The small minority of dogs that have this reaction will only
have it the first time they wear the Bark Control Collar.
You should notice a reduction in your dog's barking within the first couple of days that he wears the Bark
Control Collar. At this point, it is important to remember the learning process is still not complete. Dogs will
"test" this new learning experience and will increase their attempts to bark. This usually occurs during the
second week a dog wears the Bark Control Collar. If this does occur, remain consistent and do not alter
your use of the Bark Control Collar. You must place the Bark Control Collar on your dog in every situation
when you expect him to be quiet. If your dog is not wearing the Bark Control Collar, he may resume barking
and his learning would suffer a setback.
Note: All pets in hearing range will be affected by the ultrasonic tone.
LED Light Response
Green LED Light flashes once
Red LED Light on
Red LED Light flashes 3 times every 5 seconds
www.petsafe.net 9