Oster GCSTGS5011 Manual De Instrucciones página 12

A S SE MBL I NG THE G ARM ENT S T EAM ER
Model # GCSTGS5011
1. Remove all parts from the packaging.
2. Remove any plastic bags and stickers from the parts.
3. Place unit housing on the floor sitting on its wheels.
4. Attach the rod into the rod receptacle on the unit. Make
sure the rod-locking nut is loose. To make it loose,
untighten it by turning it counterclockwise.
5. Once the rod is inserted, tighten the rod-locking nut by
turning it clockwise until rod is tightly secured in place.
6. Unlock the two latches and extend the rod to the highest
position. Secure the rod into place by returning the latches
to the locked position.
7. Insert the hose connector into the hose receptacle by
aligning the tabs in the hose connector with the grooves
located on the hose receptacle. Once inserted, turn the
connector counterclockwise until it is locked in place.
8. Raise the two arms of the collapsible garment hanger and
fit the tips of the two hanger shafts into the tab cavities
(located on the hanger tab) and then slide the hanger
locking/unlocking fasteners all the way to lock the hanger
shafts in place.
9. Place the nozzle on the nozzle holder.
10. The unit is now assembled.
Model # GCSTGS5016
1. Remove all parts from the packaging.
2. Remove any plastic bags and stickers from the parts.
3. Place unit housing on the floor sitting on its wheels.
4. Attach the lower rods into the rod receptacle on the unit.
Tighten the two screw-in hand wheel knobs until the
rods are tightly secured in place. The two screw-in hand
wheel knobs may need to be unscrewed (by turning
counterclockwise) prior to attaching the lower rods into the
rod receptacle.
5. Unlock the six latches and extend the rods to the highest
position. Secure the rods into place by returning the latches
to the locked position.
6. Insert the hose connector into to the hose receptacle by
aligning the tabs in the hose connector with the grooves
located on the hose receptacle. Once inserted, turn the
connector counterclockwise until it is locked in place.
7. Insert the built-in hanger into the hanger receptacle and
secure it into place by locking both rod-locking latches
located on the upper rods.
8. Place the nozzle on the nozzle holder.
9. The unit is now assembled.
Eng lish-4