Dirt Sensor; Initial Start-Up; Removing Clogs - Kenmore 116.29914 Manual De Uso Y Cuidado

DIRT SENSOR
The DIRT SENSOR
light system is mount-
ed on the PowerMate
nozzle near the reset
button. It consists of a
series of two red lights
and two green lights..
DIRT
SENsoR...._.
The lights give you an indicationof the amount
of dirt particles that are passing through the
sensor on its way to the dust bag..
INITIAL START UP
When the PowerMate is first started, the fol-
lowing light sequence occurs in a two-second
time frame:
IoTwo reds come on.
2. Two greens are on and wi]l remain on until
the PowerMate nozzle is placed in use_
NOTE: if the nozzle is on a surface that has
dirt on it, dirt will be picked up by the vacuum
cleaner and the red lights might slay on
IN OPERATION
When the PowerMate is being moved back
and forth on the floor, the lightswill change
from one configuration to another as dirt is
being vacuumed..As long as the red lights are
on, dirt is passing through the wand to indicate
that the surface still needs cleaning.
When the green lights stay on as the
PowerMate is moved back and forth over an
area, the sensor is not seeing enough dirt to
warrant further cleaning of that area.
NOTE: Dirt sensor lights DO NOT function
in the FLOOR setting
REMOVING CLOGS
The vacuum cleaner creates suction that
picks up dirt.. Rapidly moving air carries the ,i'f/_._.'_._
dirt to the dust bag through the airflow pas-
//).,_
sages. The dust bag lets the air pass ,/_._/'
through, while it traps the dirt_ ////
For best cleaning results, keep the airflow ,,,_>_y t
passage openr Check the starred areas ..,_'._"
[,
occasio.ally
foFclogs, Turn o ff a nd #/ li
unplug vacuum cleaner from outlet ..___/
before checking __//
Motor
I
15