L' ARTISTICO BEA - BETTA Manual De La Instalación Y De La Instrucción página 10

Majolica mountings (where present)
WARNING!
The stove is covered in semi-refractory
majolica (not to be confused, however,
with other materials such as porcelain).
The quibbles and points or air holes are
characteristic of this hand-made majoli-
ca, and therefore are not considered
defects and do not even minimally
influence the life of the product.
To insert the majolica pieces proceed in as
follows:
1. Remove the cover (Pict.15).
2. Delicately remove the majolica pieces from
the packaging.
3. Stick the vibration-proof seal (provided) to
the upper and lower side, inside the right
and left side of the majolica and cut to size
(Pict. 15-16).
4. Insert the majolica pieces (Pict. 17).
5. Check that the inserted majolica pieces are
even with the tracks on the stove. If they
are not even, carefully recheck the position-
ing and eventually reinsert.
6. Apply the cover previously removed and
proceed to fasten it to the rear of the stove
(Pict. 18).
7. Proceed with the mounting of the display.
WARNING!
The vibration-proof seal is to be sticked
only on upper and lower side and inside
right and left side of the majolica.
Pict. 18: fastening the cover
Pict. 15: removing the cover
Pict. 16: Stiking the vibration proof seal upper and
lower side
Pict. 16: Stiking the vibration proof seal inside right
and left side
Pict. 17: inserting the majolica pieces
9