Error Messages - Olympia CM 701 Instrucciones Breves

Quick Reference
Deletion function: Reset Grand Total and Z-Counter
Start Training mode:
Set the key to PRG
2
Press the
Conclude by pressing
Proceed as follows to reset the cash register to its initial state and clear all the programmed values:
5. Disconnect the cash register power plug.
6. Open the battery compartment and remove the three AA batteries.
7. Leave the cash register for 10 minutes without any power supply; all the data is deleted as a result.
8. Replace the batteries and reconnect the power plug.

Error messages

Error messages appear in the display in the case of incorrect operation.
Error message Cause
E
Wrong key pressed.
A password has been programmed
SEC-CODE
for Z-reports.
A password has been programmed
SEC-CODE
for the clerk.
What to do if the cash register does not print?
In the event the cash register fails to print receipts or reports, check whether a special function has been activated.
Special functions are indicated by a dot in the display:
・ ・
The Receipt function has been deactivated on the cash register. There is no paper transport and,
therefore, no receipt is printed.
What to do: Press the
The cash register is in Calculator mode; the key-operated switch is set to CAL.
There is no paper transport in Calculator mode. In addition, only the calculation keys are operational.
What to do: Set the key to REG.
Olympia 5.2005
CM 701/702/711/712 Cash Register
0
and keys.
c
.
・
The cash register is in Training mode; no reports can be printed in this mode.
What to do: Deactivate Training mode. To do this, set the key-operated switch to PRG
5
and press the
(Also refer to the Section "Training mode".)
R
Input
20
Corrective measure
g
Press
Enter the 4-digit password, press
Enter the clerk number. Then enter the 3-digit password.
Conclude by pressing
key 6 times. Conclude by pressing
key to activate the receipt printing function.
Page 14
Display
20
.
n
.
R
.
q
.
Quick Reference
Confirm by pressing
c
All Rights Reserved