Control Panel; Before First Use; Using Your Coffee Maker - Hkoenig STW26 Manual De Utilización

CONTROL PANEL

BEFORE FIRST USE

Check that all accessories are complete and the unit is not damaged. Add
water into water tank to the max level and brew water for several times without
coffee powder, then discard the water. Clean all detachable parts thoroughly
with warm water.

USING YOUR COFFEE MAKER

1. Open the top lid and fill the water tank with drinking water. The water level
should not exceed the maximum level marked on the water gauge.
2. Place the funnel into the funnel support and make sure the funnel is
assembled correctly. Then put the filter correctly.
3. Add coffee powder into filter. Usually a cup of coffee need a level spoon of
coffee powder, but you may adjust according to personal taste. Then close
the top lid.
4. Place the jug on the keeping warm plate.
5. Plug the power cord into the outlet. The LCD will display 12:00 and the
colon will flash.
6. Press on/ off button once, the indicator in it will be illuminated red. The
appliance will begin working.
7. The brewing process can be interrupted by pressing the on/off button once
at any time during operation, the appliance will continue brewing once on/off
is pressed again.
Note: You can take out the jug, pour and serve at any time. The appliance will
stop dripping automatically. But the time cannot exceed 30 seconds.
8. Remove out jug to serve when finish brewing (about one minute later after
the coffee stops dripping out.)
Note: the coffee you get will less than the water you have added, as some water is absorbed
by coffee ground.
9. When the process is finished, if you do not want to serve immediately, keep
the coffee maker is energized, the coffee can be kept warm in the jug. The