Automatic Start Function - Hkoenig STW26 Manual De Utilización

blue background indicator will be distinguished after brewing within 15mins
and display shows current time. If it has not been manually disconnected at
the completion of brewing. For an optimum coffee taste, serve it just after
brewing.
10. Always turn the coffee maker off and disconnect the power supply when
not use.
Caution: When pour coffee, the momentary inclined angle of jug shall not be
more than 45 degree from the vertical position, you shall pour the coffee slowly
until the jug is empty, otherwise the coffee in the jug will rush to the bottom of
jug lid, and the coffee will flow out from two edges of lid and hurt person!

AUTOMATIC START FUNCTION

If you do not want the coffee maker to start operation immediately, for
example now it is 12:00, you hope that the coffee maker will automatically
start at 13.03 in the evening, first follow steps 1 to 5 of above section, and
then you can set the automatic start function as follows:
1. Press Set Delay button one time, the word Clock is showed at the up-right
corner on display.
2. Press the Hour and Minute button continuously to set the present time (real
clock), that is 12.00, (See fig. 1). If you not press and hold the Hour and Minute
button for 15S, the word CLOCK will not showed on
display.
Note: the time cycle is 24 hours.
3. Press Set Delay button again and the word Time
shows on up-left corner of display.
4. Set the delayed starting time by pressing Hour and Minute
Fig. 1
button repetitively, that is 13:03(see Fig. 2).
5. After setting the presetting time, press the Set Delay
button once, the letter TIMER on the LCD will disappear.
The LCD will display the current clock. The unit will begin
to brewing coffee when the delayed brew time come.
6. Press the on/off button once, the indicator in it will
illuminate blue.
Fig. 2
Note: You may cancel the automatic start function by pressing
on/off button once to stop machine, if you want to brew coffee
again immediately, you shall press on /off button once to start brewing
immediately. If you want to change the automatic start time, only following the
above 1-4 steps again.
When the time is due the indicator will illuminate green, then the unit starts
brewing. The blue background indicator will be distinguished after brewing
within 15mins and display shows current time. If it has not been manually
disconnected at the completion of brewing.