Leatt-Brace Neck Brace 4.5 Manual Del Usuario página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
5.5 | 6.5
Brace Setup
Please follow the steps to fit your neck brace
1
a.
Before you put on your 5.5 / 6.5 neck brace pull the rear thoracic back till it is stopped.
2
a.
Open the brace by pushing the release button underneath the right side of the brace (2a). You can now
pull the brace open (2b).
3
a.
Back
Front
Fit the brace with the rear thoracic facing your back (3a). Close the brace, there should be a click
to confirm that it is closed (3b).
4
b.
b.
b.
®
Copyright © 2016, Leatt
Corporation
5.5 | 6.5
Correct fitment
Please ensure that the brace wing tips are correctly aligned over your shoulder as shown below:
4
The size of the brace should be correct for your body shape and allow for adjustability to ensure correct fitment and
comfort. When correctly adjusted and worn with your helmet, the 5.5 / 6.5 neck brace should allow for a full safe
range of a rider's head and neck movements (i.e. looking up, looking down and looking side-to-side, such as when
performing an over-the-shoulder check); the 5.5 / 6.5 neck brace and the helmet must come into contact with
each other as the full safe range of normal riding head movement is reached. (5a)
5
a.
b.
Check that you have the right helmet rim clearance. Please use assistance to do this measurement, do not do
it yourself. Place a ruler in the middle of the upper rim of the brace at 90
neutral (level) position (5b). Remember to do front and back. The helmet rim should be within the zone of optimum
effectiveness (5c)
If any resistance or discomfort is experienced when attempting to complete the full safe range of head and neck
movements, or if the brace does not make contact with the helmet when the full range of movement is reached,
further adjustment, or an alternative size of 5.5 / 6.5 neck brace may be required. In extreme circumstances, it may
be necessary to purchase an alternative model of helmet in order to achieve the required level of compatibility and
safety.
If the brace interferes with any of the above mentioned, please move on to the adjustment section (p6). Please ask
the retailer or contact Leatt ® if you require further advice on sizing, adjustment or fitting.
®
Copyright © 2016, Leatt
Corporation
GB
c.
170mm
50mm
130mm
50mm
o
to the ground, with your head in a
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Neck brace 5.5Neck brace 6.5

Tabla de contenido