Electrical Requirements; Operating The Appliance; Additional Features - Morphy Richards meno Manual Del Usario

TT44340MEE Rev1:9225 47507 MEE pump - Jon

ELECTRICAL REQUIREMENTS

Check that the voltage on the rating plate of your appliance
corresponds with your house electricity supply which must
be A.C. (Alternating Current).
WARNING: This appliance must be earthed.
UK only
If the socket outlets in your home are not suitable for the
plug supplied with this appliance, the plug should be
removed and the appropriate one fitted.
WARNING: The plug removed from the mains lead, if
severed, must be destroyed, as a plug with a bared flexible
cord is hazardous if engaged into a live socket outlet.
Should the fuse in the 13 amp plug require changing,
a 13 amp BS1362 fuse must be fitted.
Features
⁄ Bread slots
¤ Lid
‹ Bread carriage lever with auto high lift feature
› Frozen button
fi Reheat button
fl Cancel button
‡ Lid release button
· Electronic variable browning control
‚ Removable crumb tray (at rear)
Key
Frozen button
Re-heat button
Cancel button
Lid release button
Before first use
• Before using the toaster for the first time, operate the
toaster without bread.
Note: The bread carriage lever ‹ will not stay down unless
the toaster is plugged in and the wall switch is on. Ventilate
the room during this process.
• As with all new electric heating elements, your toaster
emits a 'new' smell when it is first switched on. This is
quite normal and not a cause for concern. It is adviseable
to do this with the lid open.
22/12/09 16:57 Page 7

OPERATING THE APPLIANCE

1 Select the desired level of browning on the browning
control dial ·.
2 After selecting the desired level, place your bread in the
slots ⁄ and press the carriage lever down. The bread will
drop down and the lid will close ¤.
3 After the set time has been reached, the lid will open and
the bread will pop up automatically - ready for removal
from the slots. The bread carriage lever will have returned
to it's upper position and the heating element will have
switched off.
WARNING: Do not wrap the cable around the main body of
the appliance during or after use.

ADDITIONAL FEATURES

Using the re-heat button
If your toast has popped up and gone cold, the toaster
offers a re-heat facility. To use, depress the bread carriage
lever ‹ and press the re-heat button fi immediately. The
button will illuminate and the toaster will operate for a short
period re-heating the bread.
Using the frozen button
To toast frozen bread, do not adjust the browning control
from your normal setting. Place the bread in the bread slots
as normal, and press the frozen button ›.
Using the Cancel button
If you wish to interrupt the toasting cycle, press the cancel
button.
Opening and closing the lid
Whilst in use the lid can be opened by pressing the lid
release button ‡. The bread carriage leaver will pop up to
halfway. To close the lid again press the bread carriage lever
‹. This will not interrupt the cooking cycle.
Hints and tips
• In order to achieve uniform browning, we recommend you
wait a minimum of 30 seconds between each toasting, so
that the control can be automatically reset.
• If toasting one slice only, you may need to adjust the
browning control to a slightly lower setting.
• Please note: you will also notice a slight variation in toast
colour on one side of a single slice.
• Stale bread toasts more rapidly than fresh bread. Therefore,
the browning control should be set at a lower setting than
usual.
• All sorts of bread can be used, as well as teacakes, small
rolls etc. However, slices should not be so thick as to cause
g
7