Board Description; Connection Of The Power Supply Line; Type Of Cable - Avigilon ES-HD-HWS Manual De Instrucciones

6.1.3 Board description

Connect the safety earth to the relative
terminal of the J1 connector.
The board may appear different to that
illustrated.
Depending on the product version, the
board may not be equipped with all
functions.
BOARD DESCRIPTION
Connector Function
J1 Board power supply (V
J2 Auxiliary output (V
J3 Heater power supply (V
J4 Tamper switch contacts3
J5 Camera power supply (V
J7 Connector for power supply/jumper5
J8 Fan power supply (V
SW1 Tamper switch3
Tab. 1 From 100Vac to 240Vac, 24Vac or12Vdc.
1
Same voltage applied to J1.
2
Optional.
3
Different alternatives are available depending on
4
the version. V
OUT
to the type of power supply installed (7.2.1 Camera
power supply installation, page 9). V
housings powered in 12Vdc or 24Vac, with jumper
inserted in J7.
To install a power supply in 12Vdc or 24Vac refer
5
to the relative chapter (7.2.1 Camera power supply
installation, page 9).
J8
SW1 J7
Fig. 4
ES-HD-HWS/ES-HD-CWS/ES-HD-HWS-LG/ES-HD-CWS-LG
)1
IN
)2
OUT
)
OUT
)4
OUT
)
OUT
= 12Vdc or V = 24Vac, in relation
OUT
= V
OUT IN
J2 J1 J4
J3 J5
6.1.4 Connection of the power supply
line
Insert the cables for the connection to the power
supply line inside the housing through the
cable glands. The cable glands are suitable for
conductors with diameters of between 5mm and
10mm. The section of the cable inside the housing
must be sufficiently long to allow connection.
Suitably lock the cable glands.
Remove the conductors protective sheathing
and connect them to terminal (J1, 6.1.3 Board
description, page 7).
Make sure the earth conductor is at least 10mm
longer than the others.

6.1.4.1 Type of cable

The cable used for the connection to the power
supply line must be suitable for the intended use.
Comply with the current national standards on
electrical installations.
, only for
7