Chap. 1 - Information On The Machine; General Precautions; Safety Devices Installed On The Machine; Film Loading - Mastro 40M-50M2 Manual De Instrucciones

CHAP. 1 - INFORMATION ON THE MACHINE

1.1 - GENERAL PRECAUTIONS

•
The machine must be operated only by highly qualified people who are fully
aware of the safety measures described in this manual.
•
In case of a personnel turn over, training is to be provided in advance.
•
Before starting cleaning and maintenance operations, disconnect the plug
from the supply socket.
•
Assess the residual risks carefully to carry out cleaning and maintenance.
•
Cleaning and maintenance require great concentration.
•
A regular control of the electric supply cord is absolutely necessary; a
worn-out or damage cord is very dangerous.
•
If the machine shows malfunctions, it is recommended not to use it and to
abstain from trying to repair it; please call the "Service Centre".
•
The DISPENSER is used for packing foodstuffs. Do not use the machine for
other uses or for any
•
The manufacturer is not liable in the following cases:
⇒ if the machine has been tampered by non-authorized personnel;
⇒ if some parts have been substituted by non original spare parts ;
⇒ if the instructions contained in this manual are not followed accurately;
⇒ if the machine surface is not cleaned with the right product.

1.2 - SAFETY DEVICES INSTALLED ON THE MACHINE

The mechanical safety devices installed on the machine, described in this manual,
comply with EC 89/392 and mod. EC 91/368, 92/31, 93/44, 93/68.
The electrical safety devices installed on the machine, described in this manual,
comply with EC 73/23, 89/336, mod. EC 91/368, 92/31, 93/44, 93/68 and
regulations EC EN 60335-1, EN 55014.
Even though the DISPENSERS are provided with electrical and mechanical
protections (when the machine is working and for maintenance and cleaning
operations), there are still RESIDUAL RISKS (EEC 89/392 point 1.7.2) that
cannot be eliminated completely, these risks are mentionned in this manual under
WARNING . These risks are scalds caused by the loading and unloading of the
products other than foodstuffs.
4

5.3 - FILM LOADING

To load the film proceed as indicated in the figures below.
Cover
Cutting wire
Heating plate
Heating plate
Heating surface
Cover
Roll
Heating wire
Heating plate
FIG. n°10 - Film loading
40M
Roll
45K
Roll
Teflon profile
45C
Heating plate
51M
Cover
Roll
13