Ryobi RLT3725CH-A Manual De Utilización página 19

GB
F E
ASSEMBLY
Note: This shaft is designed for one time assembly.It is
not possible to disconnect the tubes once they have
been assembled/ fixed.
FRONT HANDLE (Fig. 3A)
Install the front handle onto the top side of the drive
■
shaft housing and move it to a comfortable position.
Place the bolt through the front handle as shown,
■
then install the wing nut.
Tighten wing nut securely.
■
I N S TA L L I N G T H E C R U T C H H A N D L E
(on RLT3725CH-A model only) (Fig. 3B)
Put the crutch handle (7) onto the end of the main
handle (1). Place the bolt through the hole and secure
using the nut on the other side.
INSTALLING SAFETY GUARD
CAUTION
The cut-off blade (20) on safety guard is sharp!
Contact with it can cause personal injury.
Insert the safety guard (15) onto the motor housing
■
(13) and secure it at the rear with the four screws
supplied.
Carefully peel off the tape over the cut-off blade.
■
WARNING
Never use the line trimmer without the safety
guard. It is vital for your and other people's safety
and for the good working order of the trimmer.
The failure to observe these regulations could
cause dangerous personal harm.
OPERATION
WARNING
This product may throw objects during operation,
causing injury to the operator or to bystanders.
Always wear suitable eye protection, boots,
gloves, and long, heavy pants while operating
the product.
STARTING
Before you start work, check the trimmer body and
■
cutting head for damage. Do not use damaged units.
Make sure that the area to be cut is free of stones,
■
I P NL
ASSEMBLY
S DK N FIN
English
debris, wires and any other objects.
Make sure the height of line trimmer is in most
■
comfortable position before use. Adjust the height
by pushing forward the height adjustment button (8),
then pulling/pushing the tubes until they click onto the
most suitable slot (Fig. 4).
When starting the line trimmer for the first time, check
■
that the nylon lines (18) touch or pass over the cut-off
blade. If they are not long enough, press the bump
button (17) and, at the same time, pull the line.
Secure the cord using the cord retainer. Loop the cord
■
through the cord retainer slot then around the tongue.
The cord retainer helps prevent accidental unplugging
of the cord (Fig. 5).
Connect the plug of the line trimmer to the electric
■
supply. The live power indicator (6) will show a blue
light once the unit is connected to electric power (Fig.
6).
Before doing any grass cutting, prepare the
■
cutting line.
Hold the line trimmer securely a short distance above
■
ground and turn the line trimmer on by pressing in
the lock-off button (2) then squeezing the trigger (3).
Let the line trimmer run idly for a few seconds so it
can self-adjust the length of the line.
WARNING
These steps should be repeated every time
before starting work to make sure that everything
is functioning properly and to familiarize yourself
with the line trimmer.
OPERATING THE TRIMMER
Do not start the trimmer when it is upside down or
■
when not in working position.
Switch the trimmer on before the line makes contact
■
with the grass and ensure the line is not touching
stones or debris.
Turn the line trimmer on by pressing in the lock-off
■
button (2) then squeezing the trigger (3). Once the
trimmer is running, there is no need to keep the
lock-off button compressed.
Start off slowly, when you have gained experience,
■
you will be able to use the line trimmer to its full
potential.
WARNING
Keep a firm grip with both hands during
operation.
Cut the grass by moving the line trimmer from right to
■
13
GR TR EST LT LV