Cleaning - Parkside PDM 300 C2 Manual De Instrucciones E Indicaciones De Seguridad

• Undo the four screws on the back of the multimeter and remove the back panel.
• Replace the spent F1 (F 250 mA / 300V) or F2 (F 10 A / 300 V) fuse with a new one of the same
type.
• Replace the back panel and retighten the four screws you undid before. Then, secure the battery
compartment cover again using the screw.

8.3 Cleaning

WARNING! Switch the multimeter off and remove all measurement cables before cleaning it!
To clean use a dry cloth. Never use any solvents or cleaners that may damage the plastic materials.
Make sure that no liquid gets into the housing. For more stubborn dirt, use a slightly damp cloth.
PARKSIDE PDM 300 C2
English - 61